Post 1 made on Friday February 11, 2005 at 12:48 |
CaptnHowdy Long Time Member |
Joined: Posts: | April 2003 84 |
|
|
HELP! I have to program a Pronto to switch inputs on an Extron System 7SC. Unfortunately, I do not have the original remote, but I do have a sheet with hex values supplied by Extron. They claim to use an NEC format, but I have no idea how costruct the codes necessary. Any help would be appreciated. I have 7 inputs to switch through. Details I got from Extron are... NEC Format (uPD 6121g) Custom Code : 00FFh Carrier Frequency: 38KHz
Input1: 09 Input2: 0A input3: 0B Input4: 0C Input5: 0D Input6: 0E Input7: 0F
I have been trying to figure this out on my own, but am having a hard time...Any and all help would be MUCH appreciated...
Matt aka CaptnHowdy
|
|
Post 2 made on Friday February 11, 2005 at 13:32 |
johnsfine IR Expert |
Joined: Posts: | September 2002 5,159 |
|
|
In Pronto Hex an NEC signal basically looks like: 900A 006D 0000 0001 stuv wxyz where you replace stuv with the custom code and replace wx with the command code and replace yz with the computed value FF minus the command code.
So for example, your Input1 is: 900A 006D 0000 0001 00FF 09F6
|
|
OP | Post 3 made on Friday February 11, 2005 at 14:45 |
CaptnHowdy Long Time Member |
Joined: Posts: | April 2003 84 |
|
|
johnsfine, you rock! At least I have an idea of what to do now...Seems to be working out just perfectly...
Thanks again!
Matt aka CaptnHowdy
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.